MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-408Optional Group Features
3
Console/Display Instructions Additional Information PC
! Save your entry.
Select
(QWHU.
! Return to the System Programming menu.
Select
([LW.
Group Calling Member Assignments 3
Use this procedure to assign or remove an extension to or from a calling group. A
calling group is used to direct calls to a group of people who all handle the same
type of call. A single extension number is assigned to the group and is used by
both inside and outside callers to reach the group.
To reassign an extension to a new calling group, you must remove it from its old
group before programming the new assignment.
NOTES:
1. If a linear hunting pattern is indicated on the back of the system planning
form (6d), be sure to assign extensions to the group in the exact order
that they are shown on the form. The system searches for an available
member in the order in which you assign the extensions to the group.
2. A maximum of 32 calling groups with a maximum of 20 extensions per
group is allowed.
3. An extension can belong to only one calling group. A QCC cannot be a
member of a calling group. A delay announcement device should not be
programmed as a calling group member.
4. The extension status feature must be set to the Calling Group or CMS
mode before you assign members to the group. See “Extension Status”
on page 466.
5. In Release 6.1 and later, one non-local member may be in a calling
group. A calling group cannot contain both local and non-local members.
See the
Network Reference
for information.
Summary: Group Calling Member Assignments 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 7c, Group Coverage
Factory Setting Not applicable
Valid Entries Extension numbers
Inspect Yes
To Next Page
Loading...
Need help?
General
