Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-434Optional Group Calling Features
3
Console/Display Instructions Additional Information PC
!Save your entry.
Select
(QWHU to return to Step 10 or

1H[Wto return to Step 8.

You may change the overflow receiver by
repeating Steps 7 and 8.
!Return to the System Programming menu.
Select
([LW three times.

Group Calling Message-Waiting Indicator 3
Use this procedure to designate the extension to receive message-waiting
indications (MWIs) for the calling group.
Only one extension can be designated as a message-waiting receiver for each
calling group; however, more than one calling group can use the same message-
waiting receiver. The extension assigned as a message-waiting receiver does not
have to be a member of the calling group.
Message-waiting indications cannot be sent to the extension assigned to the
group unless this option is programmed. The message-waiting receiver cannot
distinguish between messages left for the calling group and personal messages.
Summary: Group Calling Message-Waiting
Indicator 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 7d, Group Calling
Factory Setting No message-waiting receiver assigned
Valid Entries Extension number
Inspect No
Copy Option No
Console Procedure
([WHQVLRQV→More→*US&DOOLQJ→0HVVDJH→
Dial calling group ext. no.→(QWHU→Dial ext. no. for MWI
receiver
→(QWHU→([LW→([LW
PC Procedure

→→→→Type calling group ext. no.→
→Type ext. no. for MWI receiver→→→

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English