Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-446Optional Group Calling Features
3
Console/Display Instructions Additional Information PC
! Specify the type of login for the group that occurs after a power failure.
! Save your entry.
Select
(QWHU or

1H[W.

Use
1H[W to program the next calling group.
Return to Step 8.
!Return to the System Programming menu.
Select
([LW three times.

Queue Control 3
In Release 6.0 and later systems, the system manager can control the maximum
number of calls allowed in the primary calling group queue for calls that arrive on
the following types of facilities:
■ DID (Direct Inward Dialing) and dial-in TIE
■ PRI facilities programmed for dial-plan routing
■ All calls transferred from a VMI (voice messaging interface) port
■ Internal calls to the calling group
■ Internal calls to the calling group through the QCC Position-Busy backup
(PBB)
■ Intrasystem calls to the calling group
■ All private network dialed calls, including remote DID
When the number of the calls in queue reaches the programmed maximum,
subsequent callers receive a busy signal.
NOTE:NOTE:NOTE:
Dial-in tie trunks, including private tandem tie trunks (Release 6.0 and later
systems, Hybrid/PBX only) cannot be assigned directly to calling groups.
*URXS&DOOLQJ YYYY 
xxxx = number entered in Step 6
6HOHFW2QH
$XWR/RJLQ
$XWR/RJRXW
,QWHJ90,
*HQHULF90, 1H[W
Press the button or function key next to
Ã
([LW (QWHU
your selection.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English