Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-488System Features
3
Host System Dial Codes for Behind Switch Mode3
Use this procedure to assign the host system dial codes for the Transfer,
Conference, and Drop features.
When multiline telephone users press the Transfer, Conference, or Drop button,
a signal is sent to the host service and the communications system features are
not accessed. Assigning dial codes to these features ensures that users can take
advantage of them through the host system.
NOTE:NOTE:NOTE:
This procedure applies to Behind Switch mode only.
Summary: Host System Dial Codes for Behind
Switch Mode 3
Programmable by System Manager
Mode Behind Switch
Idle Condition Not required
Planning Form Form 1, System Planning
Factory Setting No host dial codes are assigned
Valid Entries Host system dial code of up to six digits
Inspect No
Copy Option No
Console Procedure
2SWLRQV→More→%HKQG6ZLWFK→Select feature→Drop→
Dial host system dial code→(QWHU→([LW→([LW
PC Procedure

→→→Select feature→7
+
I→
Type host system dial code
→→→
Procedure: Host System Dial Codes for Behind
Switch Mode 3
Console Display/Instructions Additional Information PC
! Select the Options menu.
6\VWHP3URJUDPPLQJ!
0DNHDVHOHFWLRQ
6\VWHP ([WHQVLRQV
6\V5HQXPEHU 2SWLRQV
2SHUDWRU 7DEOHV
/LQHV7UXQNV $X[(TXLS
([LW 1LJKW6UYFH


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English