Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-536Automatic Route Selection
3
In Release 6.0 and later systems, if you are setting up ARS to allow local users to
make cost-efficient calls on trunks connected to remote systems, you may wish to
check with the remote system manager to ensure that routing stipulates the most
cost-effective timing based on the rates at the remote location. If the remote
system is in a different time zone from your own, you may need to take this into
consideration as well
Summary: Start and Stop Times for Subpatterns 3
Programmable by System Manager
Mode Hybrid/PBX
Idle Condition Not required
Planning Form Form 3f, Automatic Route Selection Tables
Form 3g, Automatic Route Selection Default and
Special Numbers Tables
Factory Setting No time is specified, thus all calls are routed according to
Subpattern A.
Valid Entries 0000 to 2359
Inspect No
Copy Option No
Console Procedure
7DEOHV→$56→6XE%6WDUW→Dial table no.→(QWHU→
Drop→Dial start time→(QWHU→6XE%6WRS→Dial table
no.
→(QWHU→Drop→Dial stop time→(QWHU→([LW→([LW
PC Procedure

→→→Type table no.→→7
+
→Type
start time
→→→Type table no.→→7
+
→
Type stop time→→→
Procedure: Start and Stop Times for Subpatterns 3
Console/Display Instructions Additional Information PC
! Select the Tables menu.
6\VWHP3URJUDPPLQJ!
0DNHDVHOHFWLRQ
6\VWHP ([WHQVLRQV
6\V5HQXPEHU 2SWLRQV
2SHUDWRU 7DEOHV
/LQHV7UXQNV $X[(TXLS
([LW 1LJKW6UYFH


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English