Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-594Night Service
3
■ Activate/Deactivate Night Service Procedure
Console/Display Instructions Additional Information PC
! Turn Night Service On or Off.
! Save your entry.
Select
(QWHU.

! Return to the System Programming menu.
Select
([LW.

Night Service with Coverage Control 3
Use this procedure to enable or disable the Night Service Coverage Control
option to automatically control the status of programmed Coverage VMS Off
buttons.
When the Coverage Control option is enabled, a transition into Night Service
(either by pressing a Night Service button or automatically by the Time Set
option) automatically deactivates the VMS Coverage Off (Release 2.0 or later)
buttons (LED is off) and allows outside calls to go to VMS Coverage at night.
When the system is taken out of Night Service (either by pressing a Night
Service button or automatically by the Time Set option), programmed VMS
Coverage Off buttons are activated (LED is on) and outside calls are prevented
from going to VMS Coverage during the day.
When the Coverage Control option is disabled, Night Service status has no effect
on programmed VMS Coverage Off buttons.
Summary: Night Service with Coverage Control 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 9c, Night Service: Options
Factory Setting Disabled
1LJKW6HUY7LPH&RQWURO
Select 2Q to turn Night Service on.

6HOHFWRQH
2Q
Select 2II to turn Night Service off.

2II
([LW (QWHU

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English