MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-633Memory Card
3
While the backup is in progress, you cannot access system programming
functions, your Personal Directory, or alarm clock functions (any programmed
alarms are temporarily deactivated).
If any type of programming is taking place at an extension during the automatic
backup procedure, the backup is canceled. The system does not re-attempt the
backup.
If an automatic backup fails for any reason (including a system-busy condition), all
of the programmed alarm buttons on system operator consoles light and the
information is recorded in both the permanent error log and the last 10 error logs.
The system does not re-attempt the backup.
Also see “Backup Messages” on page 3–637
for information about errors that may
occur during the automatic backup procedure.
NOTE:NOTE:NOTE:
If an automatic backup fails for any reason (except when the failure results
because the memory card is write-protected) the automatic backup feature
is turned off. Follow the procedure below to reprogram automatic backups.
Summary: Automatic Backup 3
Programmable by System Manager
Mode All
Idle Condition Not required (No extensions are allowed to be in
programming mode including the system programming
console)
Planning Form Form 1, System Planning
Factory Setting Weekly backup: Sunday at 2:00 am
(if daily backup is selected, time is factory set for 2:00 am)
Valid Entries Daily: hhmm (00 to 23; 00 to 59)
Weekly: dhhmm (0 to 6; 00 to 23; 00 to 59)
Inspect No
Copy Option No
Console Procedure To program daily backup:
Insert memory card
→6\VWHP→%DFN5HVWRUH→
$XWR%DFNXS→'DLO\→Drop→Dial time→
(QWHU→([LW→([LW
To program weekly backup:
Insert memory card
→6\VWHP→%DFN5HVWRUH→
$XWR%DFNXS→:HHNO\→Drop→Dial day and time→
(QWHU→([LW→([LW
To Next Page
Loading...
Need help?
General
