Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-645Memory Card
3
Board Mismatch 3
A mismatch exists between the hardware components present on the current
system and the hardware components reflected in the backup file. The restore is
aborted. You can do one of the following:
■ Repeat the restore procedure with another file.
■ Modify the system hardware to match the configuration of the backup file
and repeat the restore procedure with the same file.
Strap in Place for Key Mode but Mode is
Set to Hybrid 3
!
CAUTION:
!
CAUTION:
This procedure should be performed only by qualified service personnel.
If the processor module has been set for Permanent Key mode, a restore to
Hybrid/PBX mode is not possible. A service associate must be notified in order to
modify the processor.
5HVWRUHQ
n = filename selected
5HVWRUH)DLOXUH
5(6725(,6&$1&(/('
%RDUGPLVPDWFKEHWZHHQ
FRQWUROXQLWDQGILOH
([LW
5HVWRUHQ
n = filename selected
5HVWRUH)DLOXUH
5(6725(,6&$1&(/('
5HVWRUH)LOH0RGHLV
+\EULG3%;
&RQWURO8QLW
VWUDSLQSODFHIRU.(<
([LW

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English