215585 38 Revision A
$
%
&&
Figure 3.71: Lighting Module Attached to Bracket
16. Attach module (A) to cover assembly bracket (B) using two
M4 x 16 screws (C) and M4 nuts supplied with the kit.
Torque hardware to 3 Nm (27 lbf·in).
$
%
Figure 3.72: Cover Support
17. Install cover support (B).
18. Secure cover support (B) in place with one M20 x 65
bolt (A), hardened washer, and nut.
$
%
Figure 3.73: Cover Support
19. Torque bolts (A) to 461 Nm (340 lbf·ft).
20. Remove and retain bolts (B).
ASSEMBLING THE ROTARY DISC PULL-TYPE – WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT
To Next Page
Loading...
