214880 112 Revision A
Figure 4.100: Driveline
8. Remove four M10 hex flange head bolts (A) securing
driveline assembly (B) to hub drive (C).
Figure 4.101: Drum and Tube Shield – Cutaway View
9. Slide driveline (A) downwards, tilt it to the side, and pull
driveline up and out of drum.
Figure 4.102: Right Driven Drum – View from Above
10. Use a 18 mm deep socket to remove four M12 bolts (A) and
washers holding the drum disc assembly (B) in place.
11. Remove drum disc assembly (B).
MAINTENANCE AND SERVICING
To Next Page
