214880 114 Revision A
Figure 4.105: Drum and Tube Shield – Cutaway View
4. Lightly lubricate spindle splines (A). For specifications, refer
to the inside back cover of this manual.
5. Insert driveline (B) at an angle and guide it past hub
drive (C) and drum (D).
6. Insert splined spindle end (A) into splined bore of
driveline (B).
Figure 4.106: Driveline
7. Place a bead of high-strength threadlocker
(Loctite
®
262 or equivalent) around the threads of four
M10 hex flange head bolts (A). Use the bolts to secure
driveline assembly (B) to hub drive (C). Torque bolts to
100 Nm (74 lbf·ft).
Figure 4.107: Driveline Shields
8. Position two drum shields (B) as shown. Apply a bead of
medium-strength threadlocker (Loctite
®
243 or equivalent)
around the threads of eight M8 hex flange head bolts (A).
Use the bolts to secure the drum shields in place. Torque
hardware to 27 Nm (20 lbf·ft).
MAINTENANCE AND SERVICING
To Next Page
Loading...
