214880 128 Revision A
Figure 4.134: Header Drive Gearbox Location
4. Locate gearbox (A) on the left side of the header.
Figure 4.135: Header Drive Gearbox
5. Clean area around check plug (A).
6. Remove check plug (A) with a 13 mm (1/2 in.) socket.
7. Ensure lubricant is even with bottom of check hole (A) or
slightly runs out of hole (A).
8. If necessary, remove fill plug (B) and add lubricant to
gearbox through hole (B) until lubricant runs out of
hole (A). Refer to the inside back cover of this manual for
lubricant information.
9. Reinstall plug(s) and tighten.
10. Close left driveshield and lower header.
MAINTENANCE AND SERVICING
To Next Page
Loading...
