MacDon R216 SP - Page 165

214880 157 Revision A
Problem Solution
Refer to
Symptom: Slow crop drying
Crop is bunched in windrow
Adjust forming shields/baffle.
• Positioning Forming Shield Side
Deflectors – Roll Conditioner, page
54
• Positioning Rear Baffle Deflector
Fins, page 56
Rolls not crimping crop sufficiently Decrease roll gap.
• Adjusting Roll Gap, page 49
Symptom: Excessive drying or bleaching of crop
Excessive crimping
Increase roll gap.
• Adjusting Roll Gap, page 49
Crop is spread too wide in windrow
Adjust forming shields.
• Positioning Forming Shield Side
Deflectors – Roll Conditioner, page
54
• Positioning Rear Baffle Deflector
Fins, page 56
Symptom: Poorly formed or bunchy windrows
Forming shields not properly
positioned
Adjust forming shields.
• Positioning Forming Shield Side
Deflectors – Roll Conditioner, page
54
• Positioning Rear Baffle Deflector
Fins, page 56
TROUBLESHOOTING