214880 79 Revision A
Figure 4.24: Cutterbar Disc and Cap
2. Place a pin (or equivalent) in the front hole of the rock
guard (D) to prevent disc rotation while tightening bolts.
3. Position new disc (A) on spindle ensuring that it is
positioned at a 90 degree angle in relation to the
adjacent discs.
4. Install cutter disc cap (B), and secure assembly with four
M12 bolts and washers (C). Torque bolts to 85 Nm
(63 lbf·ft).
WARNING
Ensure cutterbar is completely clear of foreign objects. Foreign
objects can be ejected with considerable force when the
machine is started and may result in serious injury or machine
damage.
5. Remove pin (or equivalent) from front hole of rock guard.
Figure 4.25: Cutterbar Curtain
6. Close the cutterbar curtain. Refer to 3.7.2 Closing Cutterbar
Curtain, page 43.
MAINTENANCE AND SERVICING
To Next Page
Loading...
