7-41
TMS800E SERVICE MANUAL POWER TRAIN
Published 01-29-2014, Control # 496-00
Installation
1. Insert two 12.7 cm (5 in) long 7/16 inch - 14 UNC guide
studs into the two upper mounting holes of the flywheel.
2. Verify flywheel cavity.
- - 8 Springs need 18.4 cm (7.25 in) bore.
- - 10 Springs need 21.7 cm (8.56 in) bore.
- - 7 Springs need 24.8 cm (9.75 in) bore.
- - 9 Springs need 24.8 cm (9.75 in) bore.
Insert the aligning tool through the release bearing
sleeve in the new clutch.
3. Put the rear driven disc on the aligning tool with the side
stamped “pressure plate” facing the pressure plate.
4. Place the intermediate plate in the clutch cover and align
the driving lugs of the plate with the slots provided.
Reference Only
To Next Page
Loading...
