- 52 -
6.2 Miscellaneous 2 TAB
• OUTPUT PROTOCOL: it permits the operator to enable a communication protocol; upon
completion of each measurement, the system transmits the acquired data by a serial,
TCP or UDP port using the selected ASCII protocol. In the case of serial protocols, the
output may use the Merlin Plus serial port or any port on an Easy Box U4S.
• PROTOCOL NAME: name of the protocol in use.
• F
REE RUNNING: This operation mode may be set to YES, so that it is enabled for any
PART PROGRAM or “USER DEFINED” pin in order to enable it for the individual PART PROGRAMS.
The measurement is acquired continuously and registered in correspondence with
the “D
ATO OK” command. In FREE RUNNING it is possible to change the active page,
inserting traceability keys and deleting the current step. All the other functions are
available after activating the “Pause” command.
To Next Page
Loading...