marposs WRP45 - Page 15

To Next Page

To Previous Page

WRS – Installation Manual

Figure 3-6. WRTS dimensions with fastening brackets.

Figure 3-7. WRTS dimensions with central

fastening.

Figure 3-8. WRTS dimensions with magnetic base.

Main Page

Table of Contents5
Standards and Warnings7
Description of the Manual7
Original Version7
Final Test and Warranty7
Conventions and Symbols Used8
Definition of Operator8
Disposal of Packaging Materials8
Description of the System Components9
Technical Specifications11
General Data of the System11
Signal Transmission13
Transmission Condition13
Dimensions14
Installation17
WRP45 - Assembling the Transmitter17
WRP60 - Assembling the Transmitter18
Inserting the Extension for Probes (Optional Accessory)19
Fitting the Stylus20
Mounting the Single and Double 90° Adapter21
Assembling the Tool Setter/Transmitter WRTS22
Inserting and Replacing the Transmitter Batteries23
Duration of the Batteries24
Fitting the Adapter Flange 2027885064 on a Type 4390190Xxx Cone26
Aligning and Fitting the WRP45 Transmitter on the Taper Shank27
Fitting the Adapter Flange 2027885080 on a Type 4390190Xxx Cone28
Aligning and Installing the WRP60 Transmitter on the Taper Shank29
Aligning and Fitting the WRTS Transmitter on the Fastening Flange30
Version with Lateral Washers30
Version with Central Screw31
WRTS System Alignment Procedure32
Tightening Torque Summary Chart34
Description of the Leds of the WRP - WRTS Transmitter36
WRS System Installation Guidelines38
General Installation Rules38
Installing the WRI Receiver Inside the Machine39
Examples Illustrating Recommended Method for Securing the WRI Receiver to the Panels40
Installing the WRI Receiver Outside the Machine41
Examples Showing Correct and Incorrect Ways of Positioning the WRI Receiver42
Multiple Receivers WRI44
Machines Positioned Side by Side45
Aligning the WRP Transmitter46
Using the Radio Frequency Channels47
Ghz ISM Band47
Distance between WRS Systems49
Using Automatic Channel Selection (ACS)49
Connecting the WRI Receiver52
I/O Diagram55
WRI Receiver/Heidenhain TNC 530 Wiring Diagram56
WRI Receiver/Heidenhain TNC 530 HSCI - 620 - 640 Wiring Diagram56
Description of Input and Output Operating Modes57
Cycle Start Modes57
Staring the Measurement Cycle59
Activating the Transmitter59
Activation Time59
Deactivating the Transmitter60
Deactivation Time60
Stop Cycle Via Timeout60
Multiple Probe Management (Multiprobe)61
Probe 1/Probe 2 Outputs61
Battery Level Low63
Error Signal63
Description of the Receiver with Integrated Interface (WRI)65
Modes for Programming66
Calibration of Optical Buttons66
Infrared Remote Control67
Buttons and Functions67
Inserting the Batteries67
Programming of the WRS System68
Main Menu68
Pairing Programming Menu69
System Pairing Procedure70
Programming Menu of WRI Receiver (BS)72
Programming Menu of Transmitter WRP - WRTS (PRB)74
Manual Activation Menu (ACT)76
System Menu (SYS)77
Maintenance79
Cleaning and Checks79
Checking the Integrity of Wiring79
Troubleshooting81

marposs WRP45 - Page 15

Table of Contents