WRS – Installation Manual
N.B.:
The battery life may vary noticeably in the presence of vibration.
[
N.B.:
The BATTERY LOW signal is activated when the remaining charge level drops below 10% and
is intended to give the operator ample time to replace the battery before the system stops
working due to a loss of energy. When the battery low signal is activated, the system maintains
all the specifications at their nominal values. In particular, the m
easurement accuracy and
repeatability values remain unaltered for as long as the interface continues to accept the
transmitted signal, provided no error situations arise (“error” LED illuminated on control panel
and ERROR output signal activated).
[
N.B.:
The panel indicator and the battery low output signal remain active even after the working cycle
has been completed; the indications are cancelled only after a new cycle has been started
correctly, with new batteries installed.
[
N.B.:
We strongly reco
mmend using only high quality batteries, with a capacity of at least 800
mAh (equivalent to at least 2 Wh) in the case of CR2 batteries, and at least 1300 mAh
(equivalent to 7 Wh) in the case of CR123A batteries. Using low quality batteries may
compromise the correct operation of the equipment and shorten battery life.
To Next Page
Loading...