4-10
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Remove control panel (See page 4-4).
Remove four 1/4” hex head screws that
secure the control panel bracket to the side
panels.
1.
2.
Lift control panel bracket and turn it over
setting it on the dryer drum.
Use a pair of pliers to squeeze two
Christmas tree clips to release wire ties from
the bracket.
Pull wires through the holes in bracket and
remove it.
3.
4.
5.
Christmas
Tree Clips
To Next Page
