4-13
Remove dryer door (See page 4-12).
Remove door strike by removing the star
head pan screw.
Rotate top of the strike away from dryer and
slide tab out of slot in dryer front panel.
Turn strike 180° to install it on the opposite
side of door opening.
1.
2.
3.
4.
Install hinge screw hole cover on opposite
side of door opening. Align two pins on the
back of cover with the two middle holes for
the door hinge screw holes.
Press pins into holes as far as they will go.
Separate door halves by removing 6 star
head screws from the inside door panel.
Lift inside door half off outside door half.
Remove two hinge screw hole covers by
gently prying two plastic pins out of the
holes for each cover .
5.
6.
7.
8.
9.
Door Strike
Star Head
Screw
Hinge Screw
Hole Cover
6 Star Head
Screws
Hinge Screw
Hole Covers
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before
operating.
To Next Page
Loading...
