Maytag MDE25PN - Remove Blower Housing; Remove Broken Belt Switch

4-25
Remove blower wheel (See page 4-23).
Remove wire connectors from thermistor
and thermal fuse (See page 4-24).
Remove the short 1/4” hex head screw that
secures blower housing to the exhaust duct.
Remove three 1/4” hex head screws from
inside the blower housing that secure it to
the motor bracket.
1.
2.
3.
4.


Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Three 1/4” Hex
Head Screws
1/4” Hex
Head Screw
Four Wire
Connectors
Remove dryer drum (See page 4-22).
Remove 2 star head screws from back of
motor bracket.
Remove two wire connectors and remove
broken belt switch switch.
1.
2.
3.


2 Star Head
Screws
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before
operating.