113 of 271
Thread Feeder Radial Bearing Replacement
The thread feeder radial bearing will have obvious defects when it requires replacement. The radial
bearings inside will develop at spots from damage or wear and the bearing will turn on the center rim
roughly, or the sealed bearing will show lubricant leakage.
Replacement Part Needed:
• P/N 30951-01 Bearing, Ball, Radial, Sealed, 5 ID X 16 OD X 5 Thk
Replacement Procedures:
Figure 1 - Radial Bearing
1. Color change to Needle #1.
2. Turn the machine OFF.
Figure 2 - Radial Bearing Behind Needlecase
3. The radial bearing will then be accessible as shown in Figure 2 above. Remove the two thread
tubes above the bearing.
4. Remove the screw with a.074” or 3mm Allen wrench and the split lock washer.
5. Install the replacement bearing and start the screw with a split lock washer loose.
•
Note: The radial bearing is a sealed bearing and does not require any additional lubrication.
6. Position the radial bearing so it depresses the stud on the back of the thread feeder arm for nee-
dle #1 about half way, then tighten the screw to torque specications.
7. Check that the bearing depresses the stud on the rest of the needle positions.
8. Replace the thread tubes in position above the screw.
To Next Page
Loading...
