255 of 271
Software Error Messages
The software generates messages pertaining to the condition of machine components and the electri-
cal current used to power the machine in case changes to the machine status or a machine error occur.
These messages make much of the machine a self-diagnostic machine. The messages below represent
true error messages that the software might generate. Messages which merely report a change in the
machine status are not included in the list below.
If you receive an error message not described below, contact Technical Support for instructions.
Error Message See Section Below
Can’t empty TI-DSP FIFO error DSP Command Errors
Can’t init color, Z not in SAFE ZONE Can’t Initialize Stepper Motors
Can’t init grabber, Z not in SAFE ZONE Can’t Initialize Stepper Motors
COLOR CHANGE seek error Stepper Motor Time Out and Index Errors
COLOR CHANGE timeout error Stepper Motor Time Out and Index Errors
DOS checksum error DSP Command Errors
DSP timeout error DSP Command Errors
Error trying to read stepper motor status Error trying to read stepper motor status
E-Stop Engaged E-Stop Engaged
ES segment register error DSP Command Errors
FEEDER stepper index error Stepper Motor Time Out and Index Errors
FEEDER timeout error Stepper Motor Time Out and Index Errors
GOTO func error Goto Func Error
GRABBER stepper index error Stepper Motor Time Out and Index Errors
GRABBER timeout error Stepper Motor Time Out and Index Errors
HOOP CENTER error Hoop Center Error
Missed headup while sewing Servo Motor Errors
No trace data No Trace Data
TI-DSP error DSP Command Errors
TI-DSP memory test error DSP Command Errors
TI-FIFO empty DSP Command Errors
X-Motor HALL Error Servo Motor Resistance Test
X-Motor Home Timeout Servo Motor Errors
X-Motor OVER CURRENT error Servo Motor Errors
X not done X- or Y- Not Done Error
X timeout error Servo Motor Errors
X tracking error Servo Motor Errors
XY home not set XY Home Not Set
Y-Motor HALL error Servo Motor Resistance Test
To Next Page
Loading...
