55 of 271
20. Locate the presser foot cam as shown in the image.
21. With the grease applicator, apply a small amount of HP grease spread fairly evenly along the entire
ght side of the presser foot cam as shown in the image.
22. Position the left upper arm front cover in its original location. You will need to rotate it back into
place in the reverse of the way it was removed.
•
WARNING!! If you proceed without mounting the left upper arm front cover, damage to your
machine will occur and a service call will be necessary.
•
Note: Melco will not be responsible for any damage to the machine or related service costs
caused by not performing this step.
23. Color change to needle #5.
24. With the needlecase holding the left upper arm cover in the appropriate position, tighten the two
screws in the left side of the upper arm front cover as shown in the image.
To Next Page
Loading...
