Parameter Address
Default Min Max Unit Logic Diagram
IEC 61850
Communication
IEC: Function group IEC
056 059
0: Without
[spacer]
Cancelling function group IEC or including it in the configuration. If the function
group is cancelled from the configuration, then all associated settings and
signals are hidden.
Important notice: Some of the parameters in function group IEC are set with
the IEC 61850 configuration tool “IED Configurator”, they cannot be modified
from the local control panel (HMI) or with the operating program, and therefore
these parameters are listed separately.
[spacer]
IEC: General enable USER
104 000
0: No
[spacer]
Enabling and disabling function group IEC.
[spacer]
IEC: Switch Config. Bank
104 043
0: don't execute
[spacer]
This parameter can only be sent individually. Accepting the previously set
communication parameters as the active communication settings.
[spacer]
IEC: Active Config. Name
104 045
2:
[spacer]
Name of the configuration bank currently valid.
Setting is carried out with the IED Configurator.
[spacer]
IEC: Active Config. Vers.
104 046
2:
[spacer]
Version number of the configuration bank currently valid.
Setting is carried out with the IED Configurator.
[spacer]
IEC: Inact. Config. Name
104 047
2:
[spacer]
Name of the inactive configuration bank.
Setting is carried out with the IED Configurator.
[spacer]
IEC: Inact. Config. Vers.
104 048
2:
[spacer]
Version number of the inactive configuration bank.
Setting is carried out with the IED Configurator.
P631
7 Settings
7-30 P631/EN M/R-11-C // P631-310-650
To Next Page
Loading...
