5-7Reference: The Preview Window
Get SCSI Chain Info
This command allows you to see the SCSI devices on your
SCSI chain and the SCSI ID number of the devices.
By default, all numbers are selected by the check boxes. To
allow ScanWizard for Windows to start up more quickly,
select only the boxes that match the SCSI ID of your
scanner (or scanners, if you have multiple scanners on your
system). This will make the ScanWizard bypass the
numbers for your other devices and focus effort on simply
detecting scanners. If you're not sure about which numbers
to specify, check all the boxes.
The SCSI Chain dialog box
Select your
interface card
here.
Click on the
Probe button to
update
information or
mount a SCSI
device if it's not
showing in the
dialog box.
SCSI devices are
shown with their
corresponding
SCSI ID numbers.
To use the SCSI Chain feature:
1 Choose the Get SCSI Chain Info command. The SCSI
Chain dialog box will appear.
2 If your scanner does not show, click on the Probe
button. Make sure your scanner is connected and
turned on.
3 Make sure too that the correct interface card is shown
in the card selection box. If not, choose the correct
interface card.
4 Check the box corresponding to your scanner or
scanners. Click OK to close the dialog box.
To let
ScanWizard
start up more
quickly, check
only the boxes
that match the
SCSI ID of your
scanner.
To Next Page
Loading...
Need help?
General