2-19Hardware Installation
Hardware Installation
for the ScanMaker 35t Plus
This section provides information on installing the hardware
for your ScanMaker 35t Plus slide scanner.
Federal Communications Commission Statement
This equipment (Model: PTS-1950, FCC ID EF9 PTS-1950) has
been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient/relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: A shielded interface cable with ferrite core installed on the
scanner connector end must be used with this equipment.
Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the
user's authority to operate the equipment.
Caution
To Next Page
Loading...
Need help?
General