Microtek ScanMaker IIG User Manual

2-28 Microtek User's Guide for Windows
Positioning the slide
The ScanMaker 35t Plus slide scanner allows you to load a slide in
two ways: By inserting it into the slide holder if you have a single
slide; or by using the film cartridge if you wish to load a filmstrip.
Using the slide holder
Follow this procedure if you're inserting a single slide.
1 Hold the slide to be inserted upright, with the front of the
slide facing the front of the scanner.
2 Insert the slide into the slide holder in the 35t Plus until you
feel it reach the bottom. The thickness of the slide should be
within 1/16" to 1/8" (about 1.5 mm to 3.0 mm). Make sure the
slide, together with its casing, stays flat and does not warp. If
the slide is shielded (in either glass or plastic), remove the
shield first before scanning, as shields may cause inaccuracies
in the scanned image.
3 To start scanning, launch the software program that came with
your ScanMaker 35t Plus scanner.
Hold the slide upright,
with the front of the
slide facing the front
of the scanner.
Insert slide into 35t Plus

Microtek ScanMaker IIG Specifications

General

Brand	Microtek
Model	ScanMaker IIG
Category	Scanner
Language	English