Federal Communications Commission Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient/relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: A shielded interface cable with ferrite core installed on
the scanner connector end must be used with this equipment.
Changes or modifications not expressly approved by
the manufacturer responsible for compliance could void
the user's authority to operate the equipment.
Caution
2
Hardware Installation
for Flatbed Scanners
Model Name FCC ID
MRS-600G2 EF9MRS-600G2
MRS-600ZS EF9MRS-600ZS
MRS-600C1 EF9MRS-600C1
MRS-1200ZS EF9MRS-1200ZS
MRS-1200F36 EF9MRS-1200F36
MRS-600E3 EF9MRS-600E3
MRS-1200E6 EF9MRS-1200E6
Trade Name
ScanMaker IIG
ScanMaker II/IIXE
ScanMaker IISP/SPX
ScanMaker IIHR
ScanMaker III
ScanMaker E3
ScanMaker E6
This section provides information on installing the hardware
for your scanner.
To Next Page
Loading...
Need help?
General