Microtek ScanMaker IIG - Scanning with the Film Mount for 35-MM Film

Hardware Installation 2-51
Operating the scanner...
C. Scanning with the film mounts for 35-mm film
Follow this procedure to scan 35-mm film.
1 Place the standard film holder on an even surface, then open
the film holder.
UNLOCK
LOCK
2 Do one of the following:
• To scan unmounted slides
Place the slide in the Microtek 35-mm slide mount, then place
the mounted slide in film mount #3 (see p. 2-43). Secure the
film under the clips of the film mount to lock the slide in.
THIS SIDE UP
AB
THIS SIDE UP
AB
AB
AB
Microtek 35 mm
Slide mount
Film
Mounted slide
Film mount #3