D-3Appendix D: The Quick Panel Utility
As mentioned in the preceding section, you will need to change parameters for
the Quick Panel only if you wish to change the way Quick Panel is set up.
Setting the Parameters
You can tell how Quick Panel is set up for each of the icons by clicking on the
space below an icon. The Tool Info box will appear when you do this, and it
shows a condensed version of the selected icon's setup information.
The information here tells you the following about the Copy function:
•
Untitled Job 1
will be the name of the job if you click on the Copy icon and
activate the copy function (in which the scanner scans a document and
sends it to the printer).
•
Postscript Printer on LPT1
is the name of the printer where the job will be
sent; this is on your LPT1.
•
Copy count=1
indicates that a single copy will be sent to the printer when
you click on the Copy icon and activate the function.
All the information in the Tool Info box reflects the parameters that have been
set or are detected by the system. These parameters are, in turn, set up through
the Command Wizard function of the Quick Panel (discussed next).
To Next Page
Loading...
