2-42 Microtek User's Guide for Windows
Operating the Scanner
• Perform the power-on self-test
• Components of the ScanMaker 45t
• Use the glass film holder
• Use the standard film holder
• Scan without the film mount
• Scan with the film mount
Performing the power-on self-test
The power-on test is a quick self-checking mechanism that the
scanner carries out after you turn it on.
This is what happens after the scanner is turned on:
1 POWER indicator on the front panel of the scanner lights up.
2 READY indicator beside the POWER indicator flashes briefly.
After a 30-second warm-up period, the scanner carries out a
self-test, with the scanner carriage moving back and forth
about a half-inch. If no problems are detected, the READY
indicator stays lit.
Note: If there are problems with the POWER and READY indicators,
see the
Troubleshooting
section in the Appendix.
3 The fluorescent lamp inside the scanner should be on too by
this time. The lamp should never go off while the scanner is on.
To Next Page
Loading...
