MICROTRONIX Access 1000 - Route Table; Creating a New Route; Editing an Existing Route; Remove an Existing Route

Microtronix Access User Guide
● TCP/IP Data Encapsulation (Conversion) Type
● Local X.25 Interface
● X.25 Connection Type (SVC or PVC)
● Called (destination) X.25 Address, or PVC Logical Channel Number
The route setup page provides a route table with all TCP/IP to X.25 route entries along with a form for
route editing.
8.1.1 Route Table
Upon loading the TCP to X.25 Routes page, the TCP to X.25 Routes table presents the current
TCP/IP to X.25 routes. The higher the route is ranked in the table the higher the priority a route will
take. As entries are added, modified and ranks adjusted, the table will change. These changes are not
finalized until the Save and Apply Changes button has been clicked.
8.1.2 Creating a New Route
Under the Inbound TCP/IP Connection section of the route edit form, enter the following:
 A Listening TCP Port number to which the remote IP host will connect.
 The Conversion Type to specify the message preservation or encapsulation method.
Under the Outbound X.25 Connection section of the route edit form, enter the following:
 The X.25 interface upon which the remote X.25 host will be reachable.
 The Connection Type, which is either a Switched Virtual Circuit (SVC) or Permanent Virtual
Circuit (PVC).
 If an SVC type has been selected, enter the Called X.25 Address. If a PVC type has been
selected, enter the Logical Channel Number.
Click the Add Entry button to add the route to the route table. The new route will be added as the
lowest rank.
Use the up and down arrows to adjust the ranking of the new route. The lower the number, the higher
the priority the route will take in the scan for a match.
NOTE: Routes added to the table do not take effect until the Save and Apply Changes button has
been clicked.
8.1.3 Editing an Existing Route
In the TCP to X.25 Routes table, a route may be selected for editing by clicking the radio button
located within the Edit column of the table in the corresponding route row. Once selected, the route will
be displayed in the Route Editing form.
Within the form the routes may be modified.
In order for the route to be updated in the route table, the Update Entry button must be pressed. The
Add Entry button may also be pressed if a new route is to be created.
8.1.4 Remove an Existing Route
In the TCP to X.25 Routes table a route may be flagged for removal by selecting the checkbox
provided in the Remove column of the table in the corresponding route row. Multiple routes may be
selected.
63