Microtronix Access User Guide
The route will not be removed until the Save and Apply Changes button has been clicked.
8.1.5 Show Facilities
Selecting Show Facilities provides additional parameters in the edit form display. This allows for
further generation of additional X.25 call facility parameters including packet and window negotiation.
8.1.6 TCP to X.25 Route Parameters
8.1.6.1 Identify inbound TCP/IP connection
Remote IP Address: IP address of the remote IP host. Used to further qualify an incoming TCP/IP
connection request.
Remote TCP Port: TCP port number of the remote IP host. Used to further qualify an incoming TCP/IP
connection request.
Binding IP Address: The IP address of the local interface to which the listening TCP port will be
bound. This field will be used as a matching criteria when finding a destination. If not specified,
connections to any local IP address will be accepted.
Listening TCP Port: TCP port number on which the gateway is listening. The remote IP host uses this
as the destination port number.
Conversion Type: Conversion type that will be used for TCP/IP data transfer, XOT, MBIT, RAW, RAW-
MBIT, RFC1006, Q-MBIT, RBP, QRBP, AEPN, OFTP, LINE, or IAC-ESC. The remote TCP/IP host
application must support this method. Refer to the Conversions And Encapsulations section for details
8.1.6.2 Generate outbound X.25 connection
Called Address: X.121 address inserted into the called (destination) address field of the outbound call
request. Not used for PVC.
Local Interface: Name of the physical or virtual local interface to which the peer X.25 device is
connected:
WAN 0 (hdlc0)
WAN 1 (hdlc1))
ANY (either WAN interface)
64
To Next Page
Loading...
