System Maintenance 16-1
16 System Maintenance
Routine system maintenance shall be carried out by the user. System maintenance after the
warranty has expired is the full responsibility of the owner / operator.
The responsibility for maintenance and management of the product after delivery resides
with the customer who has purchased the product.
If you have any questions, please contact Mindray Customer Service Department or sales
representative.
Only an authorized Mindray service engineer can perform
maintenance not specified in this operator’s manual.
For the sake of the system performance and safety, you
should perform periodical checks for the system.
16.1 Daily Maintenance
You are responsible for daily maintenance.
16.1.1 Cleaning the System
Before cleaning the system, be sure to turn off the power
and disconnect the power cord from the outlet. If you clean
the system while the power is “On”, it may result in electric
shock.
Do not spill water or other liquid into the system while you
perform the cleaning. Otherwise it may result in malfunction or
electric shock.
◼ Cleaning the probe
◼ Please refer to the operator’s manual of the corresponding transducer or “12.1.5 Probes
Cleaning and Disinfection” to perform cleaning and disinfection.
⚫ Tools: mild soapy water , dry soft cloth, soft brush
⚫ Method:
a) Wipe out the dust attached to surface of probe head, connector and cable with dry
soft cloth.
b) Use soft brush to brush the dust inside probe connector gently.
c) Remained stain or dust attached to surface of cable or surface of connector should
be washed out by cloth with a little soapy water, and then air-dry.
Don’t use cloth with water to clean the probe connector.
To Next Page
Loading...
