Mindray DP-20 - Body Mark; Body Mark Operation Procedures; Menu; Adding Body Marks

To Next Page

To Previous Page

8-4 Comments and Body Marks

NOTE:

When no object is selected, pressing the <Clear> key will clear all

comments and all measurements calipers.

After powering off, the system will clear all comments on the image.

8.2 Body Mark

The Body Mark (Pictogram) feature is used for indicating the exam position of the patient

and transducer position and orientation.

The system supports body marks for Abdomen, Cardiology, GYN, OB, Urology, Small Part

and Vascular applications.

8.2.1 Body Mark Operation Procedures

To add the first body mark:

1. Press <Body Mark> to enter the body mark status.

2. Select the body mark, adjust the position and direction of the probe icon.

3. Exit body mark mode:

⚫ Press the <Set> key to confirm the position and orientation of the probe marker and

exit the body mark mode.

⚫ Press [Body Mark] again on the control panel.

⚫ Press the [Esc] key to confirm the current operation and exit the body mark status.

8.2.2 Menu

Press <Menu> to display the body mark menu. You can:

◼ Select Bodymark library

Move the cursor to menu title, and select the desired library.

8.2.3 Adding Body Marks

◼ To add the first body mark:

(1) Enter body mark mode.

(2) Select the bodymark library through the menu title.

(3) Select the bodymark.

Move the cursor onto the desired bodymark to highlight your choice, and press

<Set> to add the selected bodymark.

(4) Press <Set> to confirm the selection.

(5) To adjust the probe position and orientation marker:

⚫ Roll the trackball to place the probe marker at the correct position.

⚫ Rotate the <Rotation> knob to adjust the orientation.

⚫ Press the <Set> key to confirm the position and orientation of the probe marker and

exit the body mark mode.

Related product manuals