4-8 Exam Preparation
◼ To save the image parameters for the current exam mode quickly:
Click [QSave] to save the image parameters in the current image mode as presets. A
dialogue box pops up to prompt you the operation will cover the current image preset
data.
◼ Exit
Click [Exit] or press <Probe> to exit, press <B>, <Freeze> or <ESC> can also exit the
screen.
4.4 Selecting Imaging Mode
Use the corresponding key in the control panel to enter the imaging modes.
For the detailed operations in each imaging mode, please refer to “5 Image Optimization”.
4.5 Activate& Continue an Exam
4.5.1 Activate an Exam
Select an exam finished within 24 hours, select the exam record, click from the menu
popped up; or, click [Active Exam] in “iStation” or “Review” screen to activate the exam.
Note:
⚫ The system can automatically load the patient information and exam data to continue
the exam.
⚫ If you want to continue an exam which data lies in an external memory database, you
have to first allow the system to load the patient data to the system’s patient
database.
4.5.2 Continue an Exam
Select an exam paused within 24 hours, select the exam record in iStation screen,
click from the menu popped up to continue the exam.
If you want to continue an exam which data lies in an external memory database, you have
to first allow the system to load the patient data to the system’s patient database.
4.6 Pause & End an Exam
4.6.1 Pause and Exam
◼ Sometimes, you have to stop an uncompleted exam due to some special causes. When
the exam is paused, the system can begin other exams.
1. Press <Patient> to enter "Patient Info" screen.
2. Click [Pause Exam].
◼ If the system is powered off during scanning, the exam status turns "paused" after the
system restart.
Only one exam can be paused every time.
To Next Page
Loading...
