6-4 Display & Cine Review
6.2.1 Entering/ Exiting Cine Review
◼ To enter cine review:
⚫ Enter "[Setup]-> [System Preset]-> [Image]-> “Freeze Config”, to set "Status after
Freeze" to be "Cine". Then the system enters the manual cine review status once
press <Freeze> to freeze the image.
⚫ Open cine files in thumbnail, iStation or Review, the system enters automatic cine
review status.
◼ To exit cine review:
⚫ Press <Freeze> key again, the system will return to image scanning and exit cine
review.
⚫ Press <Cine> or <Esc>, the images are still frozen but the system exits cine review.
6.2.2 Cine Review in 2D Mode
◼ Manual cine review
After entering the cine review of 2D mode, rolling the trackball will display the cine
images on the screen one by one.
If you roll the trackball to the left, the review sequence is reversed to the image-storing
sequence, thus the images are displayed in descending order. Whereas, if you roll the
trackball to the right, the review sequence is the same as the image-storing sequence,
thus the images are displayed in ascending order. When the reviewing image reaches
the first or the last frame, further rolling the trackball will display the last or first frame.
The cine progress bar at the bottom of the screen (as shown in the figure below):
◼ Auto Review
⚫ Reviewing all
In the manual cine review, click [Auto Play] in the menu to activate auto cine review.
⚫ Setting Region of Auto Review
You can set a segment of cine loop which can be reviewed automatically. After the auto
review region is set, the auto cine review can only be performed within this region; but
the manual cine review can be performed beyond this region. When the cine file is
saved, only the images within this region are saved.
a) Set first frame: Manually review the images until the frame which you want to set
it as start point, then click [Set First Frame] to set a start mark.
b) Set end frame: Manually review the images until the frame which you want to set
it as end point, then click [Set End Frame] to set an end mark.
c) Click [Auto Play] on the image mane.
d) Click [Auto Play] again or roll the trackball to enter manual review status; or press
<Cine> to exit cine reviewing.
e) Click [Skip to First]/ [Skip to Last] to review the first or last image.
To Next Page
Loading...
