First wipe off dust or stain attached to the cover of printer with soft dry cloth,
then clean the inside of printer. Be sure to do the cleaning maintenance
according to the operation manual if necessary.
First wipe off dust or stain attached to the cover of printer with soft dry cloth,
then clean the inside of printer. Be sure to do the cleaning maintenance
according to the operation manual if necessary.
Use soft dry cloth with a little mild soap water to wipe off the dust or stain
attached to the pedals or cable of foot switch.
16.1.2 Checking the Probe
◼ Visually check to confirm that there is no crack and expansion to probe head.
◼ Visually check to confirm that there is no deterioration or desquamation to probe cable.
◼ Visually check to confirm that there is no bend, destroyed or falling off pins to the
connector
16.1.3 Checking the Power Cable and Plug
◼ Visually check to confirm that there is no wrinkles, crack or deterioration; No crack and
expansion to the surface of adapter.
◼ Manually check to confirm that there is no looseness or rupture. The connection of plug
is reliable.
16.1.4 Checking Appearance
Check if there is any crack in the covers:
◼ Ultrasound system covers
◼ Probe appearance
16.1.5 Backup of the System Hard Drive
To prevent deterioration or loss of data stored in the system hard drive, create a backup
copy of the hard drive data (including patient info data, preset data and etc.) at regular
intervals.
To Next Page
Loading...
