12-8
12.8.2 Setting NIBP Alarm Properties
Select [Alarm Setup >>] from the [NIBP Setup] menu. You can set the alarm properties for
this parameter in the popup menu.
12.8.3 Displaying NIBP List
Select [Screens] QuickKey[Screen Setup]. You can set [NIBP List] to be displayed at the
bottom area of the screen. Then, multiple sets of most recent NIBP measurements will be
displayed. And PR displayed is derived from NIBP.
You can not display NIBP list in some screens such as the big numerics screen.
12.8.4 Setting the Pressure Unit
Select [Unit Setup >>] from the [User Maintenance] menu. In the popup menu, select
[Press. Unit] and toggle between [mmHg] and [kPa].
12.8.5 Switching On NIBP End Tone
The monitor can issue a reminder tone at the completion of NIBP measurement. The NIBP
End Tone is off by default. You can switch it on by accessing the [NIBP Setup] menu.
To Next Page
Loading...
Need help?
General
