Mindray uMEC10 User Manual

7-7
7.4.5 Setting the Reminder Tones
When the alarm volume is set to zero, or the alarm tone is reset or switched off, the patient
monitor issues a periodical reminder tone. To set the reminder tones:
1. Select [Main Menu][Maintenance >>][User Maintenance >>]enter the
required password.
2. Select [Alarm Setup >>] to enter the [Alarm Setup] menu.
3. Set the [Reminder Tones] to [On], [Off] or [Re-alarm]. When [Re-alarm] is selected,
the current physiological alarms and technical alarms marked with “Ĝ” will be
re-generated after the [Reminder Interval] if the alarm condition persists.
To set the interval between reminder tones, select [Reminder Interval] and toggle between
[1min], [2min] and [3min].
In addition, you can set the volume of alarm reminder tones. To set the volume of alarm
reminder tones, select [Main Menu][Alarm Setup >>][Others] or the [Alarm Setup]
QuickKey[Others]. Then, select [Reminder Vol] and toggle between [High], [Medium]
and [Low].
7.5 Understanding the Alarm Setup Menu
Select the [Alarm Setup] QuickKey or [Main Menu][Alarm Setup >>] to enter the
[Alarm Setup], where you can:
 Set alarm properties for all parameters.
 Change ST alarm settings.
 Change arrhythmia alarm settings.
 Set the threshold for some arrhythmia alarms.
 Change other settings.

Mindray uMEC10 Specifications

General

Resolution	800 x 600
ECG	3/5-lead ECG
EtCO2	Optional
Battery	Rechargeable lithium-ion
Battery Life	4 hours
Dimensions	110 mm
Alarm	Audible and visual alarms
Power Supply	AC 100-240V, 50/60Hz
Agent	No
O2	No