10 (119) Telephone Access System Installation and Operation Manual Version 3.7
LT-969 Copyright January 2017
Introduction
1.1.2 Elevator Restriction Units
The TX3-ER-8 or TX3-ER-8-A Elevator Restriction Units limit building
accessibility by granting visitor access only to the destination floor.
1.1.3 Other Controllers
Other Mircom controllers, such as the Elevator Restrictor Unit and the Card
Access controller, may be networked with the Lobby Control Unit. The network
options include a peer-to-peer RS-485 network, an ethernet TCP/IP network, or a
combination ethernet TCP/IP network with RS-485 subnetworks. See
Networking TX3 Panels on page 44 for more information.
Notes: In order for a panel to connect to an ethernet TCP/IP network, it
must satisfy the following conditions.
• It must be IP capable. Panels that are IP capable are usually
denoted by a “-A” or “-B” at the end of their model names.
• If the panel is not a Touch Screen, it must have a TX3-IP IP
Module installed.
1.2 Features
Features of the TX3 series include:
• Stainless steel front panel
• Universal Series enclosure with a built-in rain hood
• Large scrolling 8 x 20 LCD display that eliminates the need for an external
directory
• Back-lit 16 digit keypad with dedicated operational buttons for Page Up,
Page Down, Call and Info
• Provisions for postal lock and camera
• Multilingual Display and Voice Greeting (English, French-Canadian and
Spanish) that provides instructions on how to use the Lobby Control Unit
• Concierge/Security Desk/Guard Phone capability
• Card Access Interface
• Supports both Auto Dialer (ADC) and NSL (no phone bill)
• Ability to network panels together (peer-to-peer)
• Hands free, full duplex communication
• Flexible one to four digit resident dial codes
• Dials up to 18 digit telephone numbers
To Next Page
Loading...
