66 (119) Telephone Access System Installation and Operation Manual Version 3.7
LT-969 Copyright January 2017
Lobby Control Unit Setup
4.11 Updating Firmware
You can update the firmware on your panel with the TX3 Configurator software
by using one of the following methods.
• Firmware Upgrade Wizard
• Network Firmware Upgrade
The Firmware Upgrade Wizard can be used to update only one panel at a time. It
will work on any panel. This method does not work on 64-bit versions of
Windows.
The Network Firmware Upgrade procedure can update more than one panel at the
same time. In order to use the Network Firmware Upgrade, all of the panels must
already have firmware that supports this feature installed on them.
Refer to LT-995, TX3 Configuration and Administrator Manual, for instructions
on how to perform both of these firmware upgrade methods. LT-995 can be found
on the TX3 Configurator Software installation CD, USB flash drive, or on the
Mircom website.
4.11.1 Firmware Version Control
The firmware version number is accessible from the Configurator software and
changes whenever there is a major, minor or revision update.
The following convention is used whenever there is a major, minor or revision
change:
Initial release. Version 1.00.0
Major change. Version 2.00.0
Minor change. Version 2.01.0
Revision changes. Version 2.01.1
4.12 Beginning Configuration
The Lobby Control Unit controller is now ready for configuration using the USB.
An optional method is to use the RS-485 or modem connection.
For a complete description of the configuration and on how to establish a
connection to the Lobby Control Unit using USB, ethernet, RS-485, or modem,
see the following documentation:
• LT-995 Configuration and Administration Guide
To Next Page
Loading...
