Lobby Control Unit Setup
Version 3.7 Telephone Access System Installation and Operation Manual 67 (119)
LT-969 Copyright January 2017
• LT-973 TX3 Configurator Quick Start
Verify the following:
• Ensure that the controller and all connected devices and components are
fully operational.
• Ensure the controller DIP Switches (SW1) are set with a unique network
address.
• Ensure the Configurator software is set with the correct controller network
address.
• Ensure that your PC and the Configurator are set with the correct date and
time.
To start the configuration
1. Connect the PC to the controller using the USB port.
2. Launch the Configurator and click Connect. Once connected the
connection icon appears in the Configurator tool bar.
3. Configure the Telephone Access system using the instructions in the
Configurator Software Program TX3-MSW or the LT-995 Configuration
and Administration Guide.
To Next Page
Loading...
