Elevator Restriction Unit Installation and Configuration
Version 3.7 Telephone Access System Installation and Operation Manual 103 (119)
LT-969 Copyright January 2017
Note: DIP switch 7 is not used and must be left at the default factory
setting.
Note: For units with an TX3-IP IP Module installed, DIP Switch 8
determines how the IP address is assigned to the IP Module.
• DIP Switch 8 OFF: The IP address is assigned using a DHCP
server. This is the default factory setting.
• DIP switch 8 ON: The IP address is assigned using the TX3
Configurator software.
6.7 Updating Firmware
You can update the firmware on your panel with the TX3 Configurator software
by using one of the following methods.
• Firmware Upgrade Wizard
• Network Firmware Upgrade
The Firmware Upgrade Wizard can be used to update only one panel at a time. It
will work on any panel. This method does not work on 64-bit versions of
Windows.
The Network Firmware Upgrade procedure can update more than one panel at the
same time. In order to use the Network Firmware Upgrade, all of the panels must
already have firmware that supports this feature installed on them.
Refer to LT-995, TX3 Configuration and Administrator Manual, for instructions
on how to perform both of these firmware upgrade methods. LT-995 can be found
on the TX3 Configurator Software installation CD, USB flash drive, or on the
Mircom website.
To Next Page
Loading...
