Lobby Control Unit Setup
Version 3.7 Telephone Access System Installation and Operation Manual 65 (119)
LT-969 Copyright January 2017
4.10 Configuration Using a PC
In order to correctly utilize the capabilities of the TX3 Telephone Access System
you must first plan and establish how you want to configure the system for your
application.
The easiest way to configure the Lobby Control Unit is with the Mircom TX3-
MSW Configuration Software. This software is provided on a single CD-ROM
or USB flash drive.
The PC connects to the Lobby Control unit controller board using one of the
following methods:
• USB cable from the PC to the TX3 Main Lobby board
• Ethernet connection (Lobby Control Unit must have an IP Module)
• Modem connection (Lobby Control Unit must have a Modem Module)
The TX3 system is compatible with the following modems:
• TrendNet TFM-560U High Speed USB 2.0 Fax Modem
• TrendNet TFM-561U High Speed USB 2.0 Fax Modem
• Hiro H50113 56K V.92 USB Fax Modem
• StarTech USB56KEM2 56k V.92 USB Fax Modem
• Zoom 56K V.92 56K USB Mini External Fax Modem
Additional modems are currently being tested for compatibility.
The TX3 configuration is set using either the unit’s own keypad and display or via
the PC Configuration Software.
4.10.1 PC System Requirements
The minimum system requirements are as follows:
• Windows 7 (32 bit)
• Windows XP SP2/ Vista (32 bit)
• 512 MB RAM
• 1 GHZ CPU
• 600M disk space
•1 USB port
Note: Firmware upgrade is not supported on 64-bit systems.
To Next Page
Loading...
