12 DATA USED FOR POSITIONING CONTROL
12.7 Monitor Data
471
12
[Md.54] Start (Year: month)
The starting time (Year: month) is stored.
Refresh cycle: At start
■Reading the monitor value
• Monitoring is carried out with a hexadecimal display.
*1 If a start signal is issued against an operating axis, a record relating to this event may be output before a record relating to an earlier
start signal is output.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 390 Monitor data
[Md.5] Start (Day: hour)
The starting time (Day: hour) is stored.
Refresh cycle: At start
■Reading the monitor value
• Monitoring is carried out with a hexadecimal display.
*1 If a start signal is issued against an operating axis, a record relating to this event may be output before a record relating to an earlier
start signal is output.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 390 Monitor data
[Md.6] Start (Minute: second)
The starting time (Minute: second) is stored.
Refresh cycle: At start
■Reading the monitor value
• Monitoring is carried out with a hexadecimal display.
*1 If a start signal is issued against an operating axis, a record relating to this event may be output before a record relating to an earlier
start signal is output.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 390 Monitor data
0 to 1
01 to 12 (month)
0
b15 b12
001010000000110
b8 b4 b0
40
6
1
0 to 9 0 to 9
00 to 99 (year)
0 to 9
Monitor value
410
6
Buffer memory (stored with BCD code)
01 to 31 (day)
0
b15 b12
010100000010101
b8 b4 b0
8
1 52
Buffer memory (stored with BCD code)
0 to 3 0 to 9 0 to 2
00 to 23 (hour)
0 to 9
Monitor value
8
215
0 to 5
00
to
59 (
second
)
0
b15 b12
100 100 1
00000111
b8 b4 b0
90
7
4
Buffer memory (stored with BCD code)
0 to 5 0 to 9
00
to
59 (
minute
)
0 to 9
Monitor value
940
7
To Next Page
Loading...
