530
12 DATA USED FOR POSITIONING CONTROL
12.8 Control Data
[Cd.113] Reverse new torque value
• "1" is set in "[Cd.112] Torque change function switching request", a new reverse torque limit value is set. (when "0" is set in
"[Cd.112] Torque change function switching request", the setting value is invalid.)
• Set a value within "0" to "[Pr.17] Torque limit setting value". Set a ratio against the rated torque in 0.1% unit. (The new
torque value is invalid when "0" is set, and "[Pr.17] Torque limit setting value" or "[Cd.101] Torque output setting value"
becomes valid. The range of torque change is 1 to "[Pr.17] Torque limit setting value".
Fetch cycle: Operation cycle
■Setting value
• Set with a decimal.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 392 Control data
[Cd.130] Servo parameter write request
• Set the write request of servo parameter. Set "1" or "2" after setting "[Cd.131] Parameter No. (Setting for servo parameters
to be changed)" and "[Cd.132] Change data".
Fetch cycle: Main cycle
*1
*1 Cycle of processing executed at free time except for the positioning control. It changes by status of axis start.
■Setting value
• Set with a decimal.
Set "1" for MR-J4(W)-B, MR-JE-B, and MR-J3(W)-B, and set "2" for VC series.
Writing failure occurs when a value except "1" or "2" is set.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 392 Control data
Reverse new torque value
0 to [Pr.17] Torque limit setting value (
× 0.1%)
Setting
value
K
Servo parameter write request
1 : 1 word write request
2 : 2 words write request
Other than 1 and 2: Not request
Setting
value
K
The Simple Motion module resets the value to "0" automatically
when the parameter write access completes.
(The Simple Motion module resets the value to "3" at writing failure.)
To Next Page
Loading...
