POWER
TRAIN
-
Manual Transaxle
2-19
Input Shaft Bearing Assembly
An input shaft bearing assembly is pressed into the front case
of the transaxle. The assembly consists of the bearing housing,
bearing, and seal. The seal prevents transmission fluid leakage
into the clutch disc area. Individual components are not
service-
able, if any of the components fail the entire assembly must
be replaced. The clutch release bearing rides on the smooth
round surface of the retainer during clutch operation. Grease
is not required on the retainer where the release bearing rides.
id
To Next Page
Loading...
Need help?
General
