Mitsubishi ECLIPSE Technical Information Manual

POWER TRAIN - Automatic Transaxle
DIAGNOSTIC FUNCTION CHART
ii
Diagnostic trouble
Item
code No.
11 Internal control module (watchdog circuit test failure)
12 Battery power was disconnected since last power down
13
Internal control module (watchdog circuit shutdown)
14 Relay always On (relay contacts are welded closed)
15
Relay always Off (relay contacts are stuck open)
16
Internal control module (ROM checksum failure)
17
Internal control module (RAM checksum failure)
18
Engine speed sensor circuit
19
CCD bus communication with SBEC
20
Switched battery
21
Pressure switch circuit
OD
2-4
2-4/OD
24
LR
LWOD
LR/2-4
27
28
Check shifter signal
All
Throttle position signal
31
Hydraulic pressure switch
/ OD
/ 2-4
1 OD/2-4
35
Check ATF level
I
36
Fault immediately after a shift
I
37
Solenoid switch valve latched in the LU position
Lockup control out of range
41
Solenoid circuit error LR
1 2-4
43
OD
44
UD
45
Internal control module (engine model EEPROM cell failure)

Mitsubishi ECLIPSE Specifications

General

Brand	Mitsubishi
Model	ECLIPSE
Category	Automobile
Language	English